Pro/Forums - View Single Post

ozzy7750 · 07-08-2003, 05:01 PM

I am going to try and make a gpu cooler the same way lee has doen his cpu.

Main body would be made from acrylic, with brass tubes as inserts.

A copper base would be attached to the bottom, and a 2mm piece of acrylic will be glued to the top. for barbs I will just use brass tube, with hose clamps done up really tight.

Water comes in central inlet in a 9mm tube, goes out two side in 7mm tube.

View from above:

view from below:

07-08-2003, 05:01 PM	#300
ozzy7750 Cooling Neophyte Join Date: Apr 2003 Location: Auckland, New Zealand Posts: 42	I am going to try and make a gpu cooler the same way lee has doen his cpu. Main body would be made from acrylic, with brass tubes as inserts. A copper base would be attached to the bottom, and a 2mm piece of acrylic will be glued to the top. for barbs I will just use brass tube, with hose clamps done up really tight. Water comes in central inlet in a 9mm tube, goes out two side in 7mm tube. View from above: view from below: