Quote:
|
Now for your design I would say make the pins round or at least diamond shaped. Make the pins 3 times as high as the thickness of the base (after all milling is done). Duel outlets, not a huge gain but it is very evident in my Lemon Block and Rev. 2-5 designs. Base thickness should be around 1.5mm. Don't go much less or the block might collapse for lack of support.
|
Quote:
|
What I meant was, the shape of the pin.... make the sides concave as compared to flat. it lengthens the side, and reduces the volume of the pin slightly, each corner of the pin is now also much more prone to induce even more turbulence as a result of the curved side.
|
Thanks for the info guys. I'll work it a little and post another design