I finally got some time and got a new Rad. I decided ince everything went wrong I should expect more so I put in an old MB so incase something happens I won't lose something I care about.
From left to right. My PVC, stack is a combo Resevoir, filltube, unManifold. It cost me next to nothing but I think it will be the first thing I replace. It makes installing PCI cards a pain and the bubbles don't seem to come out very well.
The CPU block was made for an AMD so I decided since the P4 has good thermal prtection I could get away with some rubber bands and wire ties. I'm sure there more than enough pressure and my temps are decent. The 2 wasted outputs will later be used for a GPU and NB cooling but since my good graphics card isn't going in there til I know the cooling is solid I put in a freebee GF2. This MB doesn't have NB moutning holes so no NB cooling either.
I have the Johnson pump in there. I have rubber gromets on the mount but its still really loud. If anyone has suggestions about silencing this I'd liek to hear them.
Far right is the HDD cooler. For less than 20 it keeps the drives at 30C about 3C over room temp(27C). Just for comparison they used to run at nearly 40C.
I took the pics before I wired it up, As to not polute the forums with unsleeved wires. I'm not going to sleeve them as the hardware will be replaced in about a week once I'm sure the cooling won't leak.
Again thanks for the help.