thanks guys,
i am not going to use this until i get the cascade. I ran it in series with one of my diy cascade attemps and the water flow out of the end was very poor.
ozzy. i used 2mm OD tube with 1.4mm ID
a total of 28 tubes giving 43.08mm2 jet orifice area.
the cups are 3.5mm spaced 4mm apart leaving 0.5mm between each one.
i left the tubes sitting flush with the top of base plate.
if i tested this and compared it againts a maze 3 on my athlon 1100 i would say it would be very close.
my only concern is the araldite super glue i used to glue the copper into the polycarb (thanks BE).
it says that it's water proof but i left a little space on the inside for some silicon to stop the water getting to it.
Also worried about the strength of the glue holding the copper in place.
It would be better to solder the copper onto a brass barb but then you have to screw it into the polycarb and that would be impossible.
|