The damaged core is...(goes and finds it)...sitting on my bed. I have to use for it so if someone wants it or recomends a fun way of 'putting it out of its misery' tell me. Its wired up and has been ruuning for about 12 hours without a leak. Although the coolant did drop about 2 inches(3/4 in PVC) but there are now 0 bubbles in the system.
The case was chieftec scorpio. I rotated the PS 90 degrees to recover the extra room above it. Why would they put the PS 1.5inches from the top of the case is beyond me. The hole in the PS used to align with the CPU/HS of its former system. I wanted casters to help move this beast around since it weighs 30lbs stock. I liked the outriggers it used to have though so I just stuck the casters on them. I also removed the cross bar to make accessing the case easier.
The cableing is an atrocity to man, considering the Hardware will be replaced nex week I'm not going to spend my time on it now. I'll also have to make a shroud of some kind.
Before I do, If I seal the case except for the rad entrance. Then use 3 80mms + 1 or 2 120mms all for exaust will air just have to go passively through the rad? Or should I really place a fan directly onto the radiator?
Again thanks for the help couldn't of doen it without ya.