View Single Post
Unread 07-14-2003, 02:44 PM   #311
leejsmith
Cooling Savant
 
leejsmith's Avatar
 
Join Date: Mar 2003
Location: notts uk
Posts: 408
Default

the height of the tubes is very important for the impingement to work.

if it's too short or too long the jet will not form at the end of the tube mith full effect.

from what i can find it should be 3* the tube ID.

in this case that would be 4.2mm as my base is only 3mm i just left them flush.

i know thats not the correct height but from past versions of the cpu block i know how this will work.

the pump i tested the flow with is a 900l/h cheepo aquarium pump

in my rig i have a e1048. but i also have a 1000 l/h aqua bee

the cpu block and gpu block both give about the samew flow on there own.

but the cpu block is not that good anyway just one i had lying around.
leejsmith is offline   Reply With Quote