Pro/Forums - View Single Post

YiorgosX · 07-16-2003, 04:51 PM

ok, here's the latest revision of the block.
New specs are:

Base plate thickness is 1mm, pins are 4mm long.

Pins are what's left if drilling with 2.2mm bit, at 2mm spacing.
Mid plate holes are directed to the middle of the virtual square between pins.

07-16-2003, 04:51 PM	#18
YiorgosX Cooling Neophyte Join Date: Jun 2003 Location: Greece Posts: 11	ok, here's the latest revision of the block. New specs are: Base plate thickness is 1mm, pins are 4mm long. Pins are what's left if drilling with 2.2mm bit, at 2mm spacing. Mid plate holes are directed to the middle of the virtual square between pins. Last edited by YiorgosX; 07-16-2003 at 04:58 PM.