Quote:
Originally posted by Tuff
JayDee...don't forget we want to see results without Jets aswell...Just using a center inlet.
Tuff
|
Just installed it. Sorry for the delay on that but I ran out of barbs.
Jon/lee, they holes are not 1/8" unfortunatly but the probably "should be". I messed up with my measurments. The pipes have a OD of .08" and the ID of .055" and the holes in the base are only .10" is what my micrometer is telling me. Holes are not wide enough. I need to spread the pipes out more and make wider holes..... Bah!
Well at least it is on par with the maze 4 even though it is all messed up.

Will report back in a little bit with the temps on the block without jets. CPUBurn was set to an hour and it should be about up...