Pro/Forums - View Single Post

MMZ_TimeLord · 07-20-2003, 02:42 AM

Here they are folks... pictures!!!! 8-D

Reservior I had was too small to hold the new pump... so, I had Tap Plastics cut me the ¼" Acrylite pieces... cost me all of $8 US.

All I had to do was drill my holes for the cord, inlet and outlet. Once that was done, I then glued the box together. That's large type bubble-wrap that the pump is sitting on. (Less noise from the vibration the pump makes)

Install was pretty simple. I will post temp differences after it burns in for 48 hours.

07-20-2003, 02:42 AM	#2
MMZ_TimeLord Cooling Savant Join Date: Apr 2003 Location: San Mateo, CA, USA, Earth Posts: 433	Here they are folks... pictures!!!! 8-D Reservior I had was too small to hold the new pump... so, I had Tap Plastics cut me the ¼" Acrylite pieces... cost me all of $8 US. All I had to do was drill my holes for the cord, inlet and outlet. Once that was done, I then glued the box together. That's large type bubble-wrap that the pump is sitting on. (Less noise from the vibration the pump makes) Install was pretty simple. I will post temp differences after it burns in for 48 hours. __________________ MMZ>TimeLord "Oooooooooh... that's gonna leave a mark!"