Well back to the topic at hand. Here is my plans for the next version of the Jet block.
The holes in the pic are a true 1/8" wide this time which will be done on my mill being I have it here now. The base with be 3/8" thick copper and the holes will go into it 1/8" leaving 1/16" of copper under the holes. Then after thats is tested I will try a 1/4" base ect...
The pipes will be the same as the last being that pretty much the limit for the laser. Any smaller and they just melt so I am pretty much limited to the specs above and will have to work with them.
Last edited by jaydee116; 07-21-2003 at 09:07 AM.
|