Quote:
Originally posted by hara
What were you using to make the pipes?
|
Laser.
Quote:
Originally posted by MMZ_TimeLord
Jaydee... just a thought... instead of the jets dumping directly into the cups center... how about offsetting them just enough to get the flow to circulate back up and out.
Maybe slamming the water into the cups that small is creating a stagnent area by not being able to get the tubes down in the cups enough.
|
I forgot to mention the pipes will go into the cups about 1/64" (.396mm) to start with and they need to be as close to middle of the hole as possible to get the maximum impingment effect and to let the water evenly flow out of the hole.