Pro/Forums - View Single Post

TheWiz · 07-21-2003, 09:56 PM

I believe he's referring to THIS page.

I believe the use of a screwdriver was intended to open up a couple fins. Applying pressure would surely cause a leak as per this quote

"To install the shroud and fan onto the core, I used a small, blunt rounded tool to open up the fins between the core tubes where the threaded rod will pass through. Avoid brute force to jam the threaded rod through as you could tear a fin from a tube and cause a leak. If you are going to use the threaded rods to fasten the core to the case, don’t rely on a 120mm fan hole pattern to drill the holes in the case."

A thing as easy as installing shrouds caused a leak for you.hmm
:shrug:

07-21-2003, 09:56 PM	#7
TheWiz Cooling Neophyte Join Date: Sep 2002 Location: Iowa Posts: 7	RE I believe he's referring to THIS page. I believe the use of a screwdriver was intended to open up a couple fins. Applying pressure would surely cause a leak as per this quote "To install the shroud and fan onto the core, I used a small, blunt rounded tool to open up the fins between the core tubes where the threaded rod will pass through. Avoid brute force to jam the threaded rod through as you could tear a fin from a tube and cause a leak. If you are going to use the threaded rods to fasten the core to the case, don’t rely on a 120mm fan hole pattern to drill the holes in the case." A thing as easy as installing shrouds caused a leak for you.hmm :shrug: