Pro/Forums - View Single Post - Re-Design of the Jet Block.

ozzy7750 · 07-23-2003, 02:18 AM

ok, i need a little bit more clarification on this 'sucking out' issue.

is the ratio i need to work out the outlet area:inlet area, or hydraulic diameter outlet:hydraulic diameter inlet?

if it is the latter, how do i calculate the hydraulic diameter of the outlet?

i have 3.5mm cups, with 3/32 tubes (2.38mm od, 1.67mm id)

07-23-2003, 02:18 AM	#33
ozzy7750 Cooling Neophyte Join Date: Apr 2003 Location: Auckland, New Zealand Posts: 42	ok, i need a little bit more clarification on this 'sucking out' issue. is the ratio i need to work out the outlet area:inlet area, or hydraulic diameter outlet:hydraulic diameter inlet? if it is the latter, how do i calculate the hydraulic diameter of the outlet? i have 3.5mm cups, with 3/32 tubes (2.38mm od, 1.67mm id)