Hi,
I got the new core from dtek today (for those of you who read my
dtek 'holy' core) and setup the loop again. after trying to bleed the system, i noticed that the water shooting out of the end of the hose doesn't seem to be going all that strong--kinda limp. is this normal because i could have sworn flowrate was a lot faster before.
*Warning 56kers*
Bleeding
Bleeding 2
Bleeding 3
Setup*
Sorry i couldn't Save-for-web it as photoshop is on my main pc (i'm stuck on my not-so-good laptop till the watercooling project is done)
ps. if anyone is wondering about my heatercore, i put cardboard infront and behind the core to protect it from any damage.
*This is an older "version" of how it is going to be setup. the changes are as follow
- Eheim outlet to top core barb
- T-cap will be in the case going up along the edge of the motherboard