Sorry, should have been clearer. The pump is positioned so the outflow went to the back of the case, and the inflow came from the top of the case. That clearer?
At any rate, the flow was completely backwards.
No matter, I have removed everything and built my own setup. I moved the res outside of the case on a platform built on top so it sits about 4 inches higher than the rad. This allows for a nice airtrap as I have it slightly tilted up into the corner. I drilled two holes and lined them with rubber inserts for the two hoses to be run down to the rad, and my pump. From the rad goes to a Y conn to the 2 blocks, and back to another Y conn into the pump up to the res.
So far it is working like a dream as my CPU temps are 6C off the ambient. Too bad my ambient is a lot hotter here than others though...sits around 30C until around 10pm.
|