Pro/Forums - View Single Post

Ruiner · 07-27-2003, 08:52 AM

I upgraded from this homebrew block: (the one on the right)

to the Whitewater (polytop). My pump is an eheim 1048 and I use a Geo Tracker heater core and rheovolted 120 mm Panaflo L1a.

At the speeds/Vcore listed in my sig, my load (cpuburn) temps dropped from 63C to 59C. Ambient is 27C. Running the fan at full 12V drops it 2C.

Temps are a bit lower Folding: 52C.

BTW, those temps seem high across the board. I don't think my diode reads correctly.

07-27-2003, 08:52 AM	#1
Ruiner Cooling Savant Join Date: May 2003 Location: New Smyrna, FL Posts: 258	My WW upgrade results I upgraded from this homebrew block: (the one on the right) to the Whitewater (polytop). My pump is an eheim 1048 and I use a Geo Tracker heater core and rheovolted 120 mm Panaflo L1a. At the speeds/Vcore listed in my sig, my load (cpuburn) temps dropped from 63C to 59C. Ambient is 27C. Running the fan at full 12V drops it 2C. Temps are a bit lower Folding: 52C. BTW, those temps seem high across the board. I don't think my diode reads correctly. Last edited by Ruiner; 07-27-2003 at 08:59 AM.