Quote:
Originally posted by hydrogen18
my wording was a bit confusing, let me clarify. Water is injected in the middle, and seeks a path of least resistance, which would be towards the sides of the block, where there are no pins, just channels. So flow would not be maximised across the pinned area I would think.
|
The middle IS the pinned area?
It starts in the middle and goes left, right, up, and down. Which is around the pins and out the outlets. The pressure forces water in all directions. You can see the water hauling ass all around the pins exiting to the outler channel and then the outlet. How can flow not be maximised around the pin area if that is where the flow is originating from?