After doing a little searching, i was surprised to see there wasn't a dedicated thread for showing our watercooled setup. Before starting the watercooling project, looking for other people's setups was a bit of a chore. Hopefully this can be a semi-centralized location where we can all share how we setup the innards of the case.
here's my rig
(2xUV Lights. one on the bottom of the case, another hiding along the top)
Case: Lian Li PC65
Rad: DTek Pro Core
Pump: Eheim 1250
Tubing: 1/2" ClearFlex60
CPU Block: WhiteWater
GPU Block: Maze 4
Additives: Water Wetter / DTek UV Visible Blue
Extra Info: Yes, I cut the 3.5" HD Cage to fit the pro core. it was cut just deep enough so that the lower 3.5" blanking plates would still fit. The T-line going behind the floppy drive is where the air trap is hiding. the water-flow doesn't seem to be as strong as i had hoped, so after finals, i'll re-do the tubing. Electrical tape was used to prevent any possible shortages and rubbing against the side-panel window as i'm using worm clamps.
If anyone needs webspace for their system pics, drop me a PM and i'll host it.
Folks new to watercooling can see my
progression pictures (Warning: I uploaded these directly off the digicam)