TEC mfgrs recommend 150 to 300 psi clamping pressure, FAR beyond what an Athlon CPU (or even all 3 lugs) can tolerate.
A separate mechanical clamping sys is req between the cold plate (oversize) and the waterblock (again, must be larger than the TEC). The screws must be thermally insulated from the cold plate.
Yes, that's how its done.
Incomplete post.
An alternative is to adhesively bond the assy together, Artic Silver would be good. The question is if it would stay together, thermal cycling is VERY tough.
be cool
[This message has been edited by BillA (edited 01-15-2001).]
|