WOOT!
Love the belled inlet/outlets JayDee those are sweet! Have you considered changing the inlet one however so that it would go from line size down to the next smaller size to increase water velocity a bit as it enters the block? Might help just a bit.
Perhaps some small dimples in the base between pins? Easy to do with a drill press.
Those improved low resistence inlet/outlets combined with the copper construction should sure push a high flow rate and lower temps.
Looking forward to seeing your resulting temps.
Have you tested your flow rate with the new inlets yet? What change in flow vs the aluminum block do you see?
Really nice work man!
|