Pro/Forums - View Single Post

Blackeagle · 08-03-2003, 02:52 PM

I'd say a 4c+ improvement is pretty good for starters.

With a bit of tweaking it should do even better. And yet has high flow rates.

Use of that roughing end mill with a few other tweaks and this could become a very high performing block. While still holding on to almost all the flow rate advantages it now gives.

I don't suppose you'd have a White Water or Cascade about to test with? Would be interesting to see how much differance in temps and flow rate there would be.

Looking forward to you having more time to test & post more on this block.

08-03-2003, 02:52 PM	#23
Blackeagle Thermophile Join Date: Oct 2002 Location: U.S.A = Michigan Posts: 1,243	I'd say a 4c+ improvement is pretty good for starters. With a bit of tweaking it should do even better. And yet has high flow rates. Use of that roughing end mill with a few other tweaks and this could become a very high performing block. While still holding on to almost all the flow rate advantages it now gives. I don't suppose you'd have a White Water or Cascade about to test with? Would be interesting to see how much differance in temps and flow rate there would be. Looking forward to you having more time to test & post more on this block. Last edited by Blackeagle; 08-03-2003 at 03:04 PM.