thanks for the help one more question
I noticed when I checked your thread about barb sizes that D-Tek confirmed that the tygon was a little loose at the output when using the stock Eheim barb and said they would make new ones available that was back in June has anyone heard anymore about this? I didn't see any special replacement barbs at their website for the output. That is why I did the math and converted the 13mm to 0.5122" to check and see if it should fit tightly there. I wish that at least D-Tek or someone could identify the correct size completly such as 1/2,3/8 bsp or whatever the correct size is.
|