Ok, here's the scheme of things...
Imagine a 3" wide case made of plexyglass. 2 PSU's inside, 1 for the TEC, one for the system. The radiator is going to be inside this case.
The TEC/Heatsink & Fan/Copper Water Chiller block are going to be attached to the back, outside of the case.
To get the heat off of the TEC, I'm going to use a 120 MM Fan. But I'm going to cut the blades off, and turn it into a spiral blower, so it pulls the air off of the Alpha Pal, and blows air out of a vent outside of the small container that all of these are in.
When I get home, I'll make a small diagram and show you what I mean.
|