Umm I'm not sure how to make it clearer :shrug: but I thought it was pretty self explanatory IF the whole 3 page mill article was read through I also mention what I need to buy extra. You don't need to have a lubrication/cooling fluid system, but the milling bit and copper can overheat quite easily. If the copper gets hot it can get sticky and you will overheat or snap milling bits, good ones of which are not cheap. You can get by for the odd block with out a lubrication system but if you are seriously going to buy a mill with a view to using it more than a few times, it is something you will really need.
|