Pro/Forums - View Single Post - WB design like the Cascade or Jet block...

winewood · 08-12-2003, 02:23 AM

I think its a fine idea. The only question is this.. once you drill into copper or aluminum, the walls of the connected cups will tear out.. so you have a 4 leaf clover looking thing. The internal pin that separates the water into the outside cups will be/could be a jagged sharp spear or a point. Basically its almost just a larger cup with a pin in the middle.. kinda like a rotor block, that has the drilled holes separated out across the base.

08-12-2003, 02:23 AM	#2
winewood Cooling Savant Join Date: Nov 2002 Location: in my chair Posts: 574	I think its a fine idea. The only question is this.. once you drill into copper or aluminum, the walls of the connected cups will tear out.. so you have a 4 leaf clover looking thing. The internal pin that separates the water into the outside cups will be/could be a jagged sharp spear or a point. Basically its almost just a larger cup with a pin in the middle.. kinda like a rotor block, that has the drilled holes separated out across the base. __________________ -winewood-