Pro/Forums - View Single Post

Jackal · 08-12-2003, 03:32 AM

I used 10mm mill bit and I took 1mm off with each pass. Depth 1 mm was just enough for me, to handle it with bare hands. There were total 4 passes (4mm deep channel). For the back of the blok I took first pass 1 mm and then 0.5mm. (except pads for gpu and ram)

It took me around 2 hours for each block (just milling part)

08-12-2003, 03:32 AM	#24
Jackal Cooling Neophyte Join Date: Jun 2003 Location: Slovenia Posts: 45	I used 10mm mill bit and I took 1mm off with each pass. Depth 1 mm was just enough for me, to handle it with bare hands. There were total 4 passes (4mm deep channel). For the back of the blok I took first pass 1 mm and then 0.5mm. (except pads for gpu and ram) It took me around 2 hours for each block (just milling part)