Well I changed course
again . I know Bigben might start to
.
I have been tweaking the laser at work to try and get it back to engraving like new and have come as close as I can get being the boss doesn't want to spend a dime on getting replacement parts it desperatly needs...
Anyway I made a new desing today. It has 11 jets. The holes will be drilled with a 1/8" endmill into 1/4" thick copper. I will have to measure the jets once I get home with my micrometer as they are smaller than what they were drawn to be because the laser melts away a little more material than the design is drawn to. The holes I did a pilot hole with the laser and am going to attempt to drill them out with a drill bit.
Also this is a single inlet and SINGLE outlet design. I threw this together because I am trying to route 3 computers onto one loop and having 3 barbs on one block makes it a bitch. I will leave the Lemon Block though as the last block in the loop because it is the best block and because I can easily rought the dual outlets into the resivore.
My capture card is messed up again so it looks like I will have to reload the drivers and what not before I can put up anymore pics. Hopefully this weekend I can find sometime.