Quote by ondaedg
"First off, we must connect the 1 or 2 ohm resistors I mentioned in the supplies list across the +5 volt connections. In other words, one end of the resistor must go to one of the red (+5v) wires and the other end of the resistor must go to one of the black wires (negative)."
So basically a +5v red lead stemming from the pcb goes to the 1 or 2 ohm 25w resistor, to a black(negative) lead stemming from the pcb. Is this correct? If my pelt has a molex connector, I can plug it into either of the power supplies, correct? What do I do with the leads that were cut? I don't think I exactly understand it. Any help would be greatly appreciated! Thx
|