Pro/Forums - View Single Post

eX&TriC · 10-22-2001, 02:44 PM

Kryotherm DRIFT-0,8
Peltier element with the following specifications:
Qmax = 172 watt
delta T = 69° C
Vmax = 24.6V
Imax = 11.3A
Dimensions = 40 x 40 x 3.4 mm
Special = silicone-sealed

I was wondering about powering the pelt with two ATX 300W PSU in serie > 24V and 10A. Any advice
tips or suggestions about this. Is there a better way ? Iwould only like to use AT(X) PSU.

If I were to use a 16V pelt, what would be the best setup?

Greetz and tnx

10-22-2001, 02:44 PM	#1
eX&TriC Cooling Neophyte Join Date: Oct 2001 Location: Belgium (center of the universe) Posts: 51	Powering pelts (2 questions) Kryotherm DRIFT-0,8 Peltier element with the following specifications: Qmax = 172 watt delta T = 69° C Vmax = 24.6V Imax = 11.3A Dimensions = 40 x 40 x 3.4 mm Special = silicone-sealed I was wondering about powering the pelt with two ATX 300W PSU in serie > 24V and 10A. Any advice tips or suggestions about this. Is there a better way ? Iwould only like to use AT(X) PSU. If I were to use a 16V pelt, what would be the best setup? Greetz and tnx __________________ P4 1.8A @ 2.4 - 256MB PC1066 - GF4 355/780 Peltchilled-