Pro/Forums - View Single Post

Cablepro · 01-22-2001, 08:51 PM

I put it full dial for about 3 seconds with the multimeter already on the outputs...I figured it was bad to put it past 24V, so I dialed it down immediately...but thanks for the warning...so you think that if I put the power supply to 24V, even though it will probably only put out 7.5A, that I wont freak out the power supply considering the pelt has a 11.3A draw? or is that just maximum, and probably not actually the maximum for 24V?

in other words, is it probable that the 11.3A Imax is with lower voltage than 24?...

01-22-2001, 08:51 PM	#13
Cablepro Cooling Neophyte Join Date: Jan 2001 Location: Daytona Beach, FL USA Posts: 93	I put it full dial for about 3 seconds with the multimeter already on the outputs...I figured it was bad to put it past 24V, so I dialed it down immediately...but thanks for the warning...so you think that if I put the power supply to 24V, even though it will probably only put out 7.5A, that I wont freak out the power supply considering the pelt has a 11.3A draw? or is that just maximum, and probably not actually the maximum for 24V? in other words, is it probable that the 11.3A Imax is with lower voltage than 24?...