Pro/Forums - View Single Post

jaydee · 08-21-2003, 11:21 AM

I used one of my dead Epox 8K7A's to get the mounting and what not lined out.

---
The Duron 1gig was my choice as my other 4 computers are being used for DF and I had this chip sitting on a shelf for backup. Will be mounting my Maze4 and My Copper lemon Block to this CPU first on my Abit KD7. Once well tested with those blocks I will setup the Direct die block and compare against the other two. Note I will have the type k thermocoupler mounted under this CPU for better accuracy and repeatablility. Alo have another type K thermocoupler and a thermister all calibrated together for the best accuaracy I can get with what I have.

---
Jets inside containment area.

--
The middle peice with jets lasered in and then milled around to fit inside the containment peice.

--
Containment peice with sloped side to direct the water out of the containment area and to the outlet.

08-21-2003, 11:21 AM	#4
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	I used one of my dead Epox 8K7A's to get the mounting and what not lined out. --- The Duron 1gig was my choice as my other 4 computers are being used for DF and I had this chip sitting on a shelf for backup. Will be mounting my Maze4 and My Copper lemon Block to this CPU first on my Abit KD7. Once well tested with those blocks I will setup the Direct die block and compare against the other two. Note I will have the type k thermocoupler mounted under this CPU for better accuracy and repeatablility. Alo have another type K thermocoupler and a thermister all calibrated together for the best accuaracy I can get with what I have. --- Jets inside containment area. -- The middle peice with jets lasered in and then milled around to fit inside the containment peice. -- Containment peice with sloped side to direct the water out of the containment area and to the outlet.