Quote:
Originally posted by joemac
They do look alike mfpmax, What kind of numbers where you getting with it ? How did you cut your pins?
|
Not sure about numbers...can't remember much...this was back in 2000/2001 on a P5A board and the rig in the link in my sig. I just remember when I had a under powered peltier hooked up and was running 600MHz, at idle it was reporting 59F...but it shot to 120 under load because of it...so I say it was proably doing 90-100F on average proably without the peltier at 600MHz.
Since it was a heatsink, I bent a good portion off....then I took a milling bit and flattend the outside portion off. So techncally they aren't pins, they are fins.
But yeah, thats how we did it back in the day.
