Pro/Forums - View Single Post - Should I add Northbridge into the water circuit?

msv · 08-27-2003, 04:53 AM

Zoson, was Your two BI rads in serie or parallell?
My main problem with my BIM is the puny 1/4" barbs, choking every kind of water flow.
With all respect, if Your BI rads where in serie You would most likely have had better temps with the BIX alone, without the flow restricitng BIM.
Boli: My experience with the BIM has led me to purchase a DD heater core. Two parallell BIMs are better than one, so probably they will handle the north bridge as well, but if You´re going for high overclock a bigger rad will serve You better.
regards
Mikael S.

08-27-2003, 04:53 AM	#5
msv Cooling Savant Join Date: Dec 2002 Location: Sweden Posts: 336	Zoson, was Your two BI rads in serie or parallell? My main problem with my BIM is the puny 1/4" barbs, choking every kind of water flow. With all respect, if Your BI rads where in serie You would most likely have had better temps with the BIX alone, without the flow restricitng BIM. Boli: My experience with the BIM has led me to purchase a DD heater core. Two parallell BIMs are better than one, so probably they will handle the north bridge as well, but if You´re going for high overclock a bigger rad will serve You better. regards Mikael S. __________________ The only constant factor in all Your failures is You. Catapultam habeo. Nisi pecuniam omnen mihi habis, ad caput tuum saxum immane mittam.