EDIT: Did not read last part of your post....
When you say first and middle, are you talking about the pot adjuster knob facing you, and the first being on the left in that perspective? If so, then that is how this pot is set up. Any way you could draw that same diagram with the 3 pins of each pot facing down, as if you were looking at the pot from the adjuster knob? I am having a hard time seeing it... EDIT -- Actually, after drawing it out w/ a few assumptoins, I am seeing it much clearer now. The ground for both is connected then brought back to pcb. I would still like to see another drawing, to make sure I am getting it right.
EDIT: I did a lil drawing of what I think you are talking about. Please tell me if it is on the mark.
BrianW
__________________
Water Cooled Inwin Q500 (Dual Rads: Rad1 = DTEK Pro Core | Rad2 = Blick Ice Estreme, Hydor L30, Dangerden Maze2, Bay Res Typhoon Reservoir, 1/2 " DD Tygon Thick Wall Hose).
Flow: Res, Pump, CPU watervlock, Y into both rads, both rads into res independently.
Athlon XP 1800+ (@ 1731 - 150mhz fsb.), on a Asus A7N266-c, and a Radeon 9000 *waiting for RMA'd Saphire 9800 ultra from Newegg)
Last edited by BrianW; 08-31-2003 at 12:25 AM.
|