Pro/Forums - View Single Post

B2BigAl · 09-01-2003, 11:14 AM

I was under the impression that the WW didn't require a lot of flow, but a higher head due to the impingement. Either way I would've figured the eheim 1048 would've been sufficient. I did clean everything out just 2 days ago when I set this cooling loop up in a new case, but still no difference. The block should have even pressure, I turned each of the four mounting screws the same number of turns, in a criss cross pattern to ensure it was an even pressure. Also, The difference between the AS3 and the PCM+ was only ~1C, not 2-3C. Thanks for the suggestions though, I'm no sure what else to try.

09-01-2003, 11:14 AM	#8
B2BigAl Cooling Neophyte Join Date: May 2003 Location: Wouldn't you like to know Posts: 11	I was under the impression that the WW didn't require a lot of flow, but a higher head due to the impingement. Either way I would've figured the eheim 1048 would've been sufficient. I did clean everything out just 2 days ago when I set this cooling loop up in a new case, but still no difference. The block should have even pressure, I turned each of the four mounting screws the same number of turns, in a criss cross pattern to ensure it was an even pressure. Also, The difference between the AS3 and the PCM+ was only ~1C, not 2-3C. Thanks for the suggestions though, I'm no sure what else to try.