ok lets take this one step farther,
my chiller is in a wet dry filter system.
The wet dry would act something like a bong set up removing heat , then passing through the filtering system (IF you remove the charcoal bags and leave only the foam filter wich is as wide as the tank and 3 inches square thus low restrition ) and the chiller taking care of the rest of the heat before returning to the pump and block.
the wet dry would need a few mods to do this but not on the scale of thousands of dollars.
While I know salt water fish and reef tanks are not quite as critical to temp as Wc block testing, it is important enough that it has to be done and 15 dregees below ambient ( around 60 degrees F ) is what they try to achieve.
I know I am probably way off base and you can tell me to STFU anytime, I know alot more about salt aquariums than I do water cooling PC's. just trying to apply same basic technology since that is what I know.
I know I am reaching but it may be that extra little bit to make the temp stable.
Aardil
|