View Single Post
Unread 09-09-2003, 10:00 PM   #41
jaydee
Put up or Shut Up
 
jaydee's Avatar
 
Join Date: Dec 2001
Location: Spokane WA
Posts: 6,506
Default

Quote:
Originally posted by pHaestus
I thought I explained earlier that I use these measurements to verify that my test setup is working properly. This is something I find useful (confidence in my results).
Question still not answered though. How is either the inlet/outlet and/or base plate temp a verification? What makes those temps any better than the other? And how are you taking these temps for only a few hundred $'s accurately? Stuff isn't adding up in this thread. We have Ben saying it will take several 1,000 $'s to make a accurate measurement for this and we have you that says you got a couple hundred $'s and say you can take those measurements accurately enough to be useful.
Quote:
So to recap: what we have here is people with experience and/or expertise telling you something wont work or is really difficult. On the other hand we have those without experience full of enthusiasm and sure it's all straightforward.
No, what we have here is some claiming to be experienced (some are some are not) and not sharing their claimed knowledge to inform the less knowledgeable. Instead we have "do it this way or don't do it at all" with no explanation why it needs to be done that way.

There is way to much conflicting input here to be useful IMO.
jaydee is offline   Reply With Quote