Asymetrical White Water plans
As a newbie to water cooling I was wondering what the effects of positioning of a Y connector in my proposed set-up would be.
Eheim 1250 to DTEC White Water
(one in and two outs)
Taking one of the outs through the GPU Dangerden and the other through the the chipset Dangerden
Into a resevoir
Into a (thermochill) rad
Back to the pump
All 1/2 ID...
I can Y connect the two branches before the other blocks, within the resevoir,
before the rad or before the pump (doubling up resevoirs and rads as needed).
Current thought is to join them into a resevoir (two in and one out)
I realise the flow after the WW will be reduced - does anyone have any suggestions/thoughts? Will the asymetry cause problems?
Also as a newbie:
Any particular advantages on positioning the pump high up?
Thanks in advance
Abe
|