View Single Post
Unread 09-15-2003, 03:20 PM   #1
dogbait
Cooling Neophyte
 
dogbait's Avatar
 
Join Date: Jun 2003
Location: London, UK
Posts: 70
Default pt. I - The Iwaki has landed. pt. II - Plumbing it?

Thought I'd show off my new gadget, an Iwaki MD-15R(M), (and ask the wise ones here how to plumb it too!).





It's threaded, with 3/4" BSP, and the inner boare diameter is just over 3/8". What I'm hoping to do to get it setup quickly with two Swiftech MCW5000 blocks is to use a 3/4" BSP >> 3/8" barb so that 1/2" OD tubing can be used.

The rad. can take either 3/8" ID or 1/2" ID tubing, but for simplicity's sake, I'd like to plumb the whole system with 3/8" ID tubing and then upgrade later when I add more blocks.

Does anyone know where the above barbs could be purchased?
I've only been able to find 3/4" >> 3/4" or to 15mm or to 22mm (standard plumbing sizes here in the UK). Or perhaps suggest a quick solution since I don't plan to build my reservoir/manifold just yet.
dogbait is offline   Reply With Quote