View Single Post
Unread 09-15-2003, 10:20 PM   #3
Blackeagle
Thermophile
 
Join Date: Oct 2002
Location: U.S.A = Michigan
Posts: 1,243
Default

It would help all here to help you if you spec the case this is going into, or if it will be outside the case.

Knowing the rad and blocks to be used with the pump would also help. Without enough info giving advise is like taking a shot in the dark. That is why I spec'd my intentions rather than try to answer your questions directly.

The reason for my large lines is that the larger the lines the lower the velocity of the water flowing through them and thus lower head loss.

A good starting point would also be for you to read the aritcle by pHaestus on maximizing flow in fittings and lines in the articles section of the front page. A very good article indeed.

Last edited by Blackeagle; 09-15-2003 at 10:31 PM.
Blackeagle is offline   Reply With Quote