Pro/Forums - View Single Post

pippin88 · 09-17-2003, 08:58 PM

I'm in Australia, and there is a much smaller supply of modding stuff like grills etc. I think the demand would be much higher.

If I do get a machine, I have no problems doing a lot of work for no profit to just pay off the machine. This is a long term investment, and I have a fair amount of spare time to do this stuff in.

Another question:
Do these smaller lasers require three phase power?
Will it be a problem getting one from the US with the power being different? (110V, and 240V for AU)

Also cutting time is another issue. How long does it take to cut simple shapes? I believe that the slower you go the better the finish.

09-17-2003, 08:58 PM	#6
pippin88 Cooling Savant Join Date: Oct 2002 Location: Australia Posts: 285	I'm in Australia, and there is a much smaller supply of modding stuff like grills etc. I think the demand would be much higher. If I do get a machine, I have no problems doing a lot of work for no profit to just pay off the machine. This is a long term investment, and I have a fair amount of spare time to do this stuff in. Another question: Do these smaller lasers require three phase power? Will it be a problem getting one from the US with the power being different? (110V, and 240V for AU) Also cutting time is another issue. How long does it take to cut simple shapes? I believe that the slower you go the better the finish.