Pro/Forums - View Single Post - Design verification... Need your help folks!

MMZ_TimeLord · 09-18-2003, 02:25 AM

Okay... for Ben2k, Cathar, Jaydee and many others who have WAY more knowledge about this stuff than I do.

Below is the design. It shows 3 sizes of copper tube to use for the jets. The drawing shows the largest (1/8") used. This gives 30 jets and a flow area roughly 3 times that of the inlet tube.

Will this be okay? or should I use a smaller jet tube size and get more of them in there?

This is mainly just a test of the general design to go with my radiator that's on order. I want to change the block first, then the radiator and compare.

Thanks in advance everyone!

09-18-2003, 02:25 AM	#1
MMZ_TimeLord Cooling Savant Join Date: Apr 2003 Location: San Mateo, CA, USA, Earth Posts: 433	Design verification... Need your help folks! Okay... for Ben2k, Cathar, Jaydee and many others who have WAY more knowledge about this stuff than I do. Below is the design. It shows 3 sizes of copper tube to use for the jets. The drawing shows the largest (1/8") used. This gives 30 jets and a flow area roughly 3 times that of the inlet tube. Will this be okay? or should I use a smaller jet tube size and get more of them in there? This is mainly just a test of the general design to go with my radiator that's on order. I want to change the block first, then the radiator and compare. Thanks in advance everyone! __________________ MMZ>TimeLord "Oooooooooh... that's gonna leave a mark!"