Pro/Forums - View Single Post

TerraMex · 09-21-2003, 06:45 PM

Assuming the other side equal and form the assembly, and the two wire pairs, it looks like it's a peltier sandwitch, at least. Double that is. One on each side. It would be interesting to see the middle plates without the neoprene.

Basically it's a chiller. The blocks cool each of the hot sides, both cool sides must be attached to a maze type block? (usually, for maximum effect) . Althou i am intrigued about the noticeably smaller size outlet (inlet?) barb.

( Well, you could just circulate water to a deposit for the main cooling rig. And you dont actually need a very large id (or very large flowrate) with a chiller setup (less restrictions when you eliminate the radiator). But i'm just guessing )

09-21-2003, 06:45 PM	#26
TerraMex Cooling Savant Join Date: Nov 2002 Location: Portugal, Europe Posts: 870	Assuming the other side equal and form the assembly, and the two wire pairs, it looks like it's a peltier sandwitch, at least. Double that is. One on each side. It would be interesting to see the middle plates without the neoprene. Basically it's a chiller. The blocks cool each of the hot sides, both cool sides must be attached to a maze type block? (usually, for maximum effect) . Althou i am intrigued about the noticeably smaller size outlet (inlet?) barb. ( Well, you could just circulate water to a deposit for the main cooling rig. And you dont actually need a very large id (or very large flowrate) with a chiller setup (less restrictions when you eliminate the radiator). But i'm just guessing ) __________________ "we need more cowbell."