Pro/Forums - View Single Post - Closed loop and water peltier cooled water?

Butcher · 09-17-2001, 08:54 AM

correct clamping pressure for a TEC is about 200 psi, I don't think the dd maze2 allows that much whithout breaking the block - the sttel (I'm assuming they're steel) screws would tear the threads out of the softer copper block.

I'm planning to clamp peltiers with steel bar and steel screws / nuts, should allow very high clamping pressures as steel is a lot harder than copper.

09-17-2001, 08:54 AM	#17
Butcher Thermophile Join Date: May 2001 Location: UK Posts: 1,064	correct clamping pressure for a TEC is about 200 psi, I don't think the dd maze2 allows that much whithout breaking the block - the sttel (I'm assuming they're steel) screws would tear the threads out of the softer copper block. I'm planning to clamp peltiers with steel bar and steel screws / nuts, should allow very high clamping pressures as steel is a lot harder than copper. __________________ Once upon a time, in a land far far away...