Pro/Forums - View Single Post

Aardil · 09-24-2003, 06:02 PM

ok I am ordering 2 MPC600's tommorow for my new rig, If I understand Billa correctly, the inlet plummed with 1/2" I.D. is ok?
or should I go to 5/8 ID for the inlet?
I had orginally planned on using 2 1250's (since I have 1 already) but using Cathars's Cascade blocks, he lead me to believe the 1250's would work but really needed more. The inlet hose is only about 3 inches long and is a straight shot from the res. I had originally planned on going with the 5/8 but reading the spec sheets I see the MCP600 has a 1/2 inlet. It can still be changed to 5/8 at this point if it would be better.
Also the pumps are standing on their tail end Inlet pointing up, Res is mounted above pumps if that makes any difference.
Thanks for your help
Aardil

09-24-2003, 06:02 PM	#44
Aardil Cooling Savant Join Date: Oct 2002 Location: Louisiana Posts: 174	MPC600 ok I am ordering 2 MPC600's tommorow for my new rig, If I understand Billa correctly, the inlet plummed with 1/2" I.D. is ok? or should I go to 5/8 ID for the inlet? I had orginally planned on using 2 1250's (since I have 1 already) but using Cathars's Cascade blocks, he lead me to believe the 1250's would work but really needed more. The inlet hose is only about 3 inches long and is a straight shot from the res. I had originally planned on going with the 5/8 but reading the spec sheets I see the MCP600 has a 1/2 inlet. It can still be changed to 5/8 at this point if it would be better. Also the pumps are standing on their tail end Inlet pointing up, Res is mounted above pumps if that makes any difference. Thanks for your help Aardil