Pro/Forums - View Single Post

MMZ_TimeLord · 09-25-2003, 11:43 AM

Very little to update this morning... did drill out the bolt holes in the acrylic and get some things lined up.

FL3JM & maxim,

This block is for a P4 with the IHS in place. This is just to give me some experience building this type of block before I commit to building a smaller jet version.

I do not care about the flow to the outer jets as the flow through this will be WAY better than this block I currently have in place.

This is what I am building... They are both based on a 2 inch by 3 inch, ½ inch thick block of copper for a base.

Now you tell me... is this gonna be better for flow? Flow right now is what is hurting my system. :shrug:

09-25-2003, 11:43 AM	#20
MMZ_TimeLord Cooling Savant Join Date: Apr 2003 Location: San Mateo, CA, USA, Earth Posts: 433	Very little to update this morning... did drill out the bolt holes in the acrylic and get some things lined up. FL3JM & maxim, This block is for a P4 with the IHS in place. This is just to give me some experience building this type of block before I commit to building a smaller jet version. I do not care about the flow to the outer jets as the flow through this will be WAY better than this block I currently have in place. This is what I am building... They are both based on a 2 inch by 3 inch, ½ inch thick block of copper for a base. Now you tell me... is this gonna be better for flow? Flow right now is what is hurting my system. :shrug: __________________ MMZ>TimeLord "Oooooooooh... that's gonna leave a mark!"