Pro/Forums - View Single Post - Power sloution for two 172W pletiers for less than $200??

Petrus · 08-03-2001, 09:37 PM

Thank you mASO for your reply! I appretiate it! Unfortunally I have allready read that article. Since there is only room for two more AT/ATX powersupplies in my case (with some minor modifications that is), that means I have to get hold of two PSUs that can deliver 11.5A @ 12V. I'm not quite up to speed on PC PSU prices but if I'm not mistaken these aren't exactly cheap, right?? So I figured, if I'm going to spend $$$ then I might just as well buy a smaller dedicated 20-24V PSU that will deliver atleast 23A. A cleaner sollution in my oppinion.

Is it possible to run the peltiers in series on a 40V PSU that delivers 11.5A?? If so, that could be an option too.

08-03-2001, 09:37 PM	#3
Petrus Cooling Neophyte Join Date: Jun 2001 Location: Umeå, Sweden Posts: 18	Thank you mASO for your reply! I appretiate it! Unfortunally I have allready read that article. Since there is only room for two more AT/ATX powersupplies in my case (with some minor modifications that is), that means I have to get hold of two PSUs that can deliver 11.5A @ 12V. I'm not quite up to speed on PC PSU prices but if I'm not mistaken these aren't exactly cheap, right?? So I figured, if I'm going to spend $$$ then I might just as well buy a smaller dedicated 20-24V PSU that will deliver atleast 23A. A cleaner sollution in my oppinion. Is it possible to run the peltiers in series on a 40V PSU that delivers 11.5A?? If so, that could be an option too. __________________ "Hard to se The Dark Side is"