Thread: Endmills :)
View Single Post
Unread 10-07-2003, 10:19 PM   #9
Zymrgy
Cooling Neophyte
 
Join Date: Apr 2003
Location: USA
Posts: 96
Default

The smallest endmill I have used was "slightly" larger than this...at .015". I used a special air driven spindle to turn it at 30,000 rpm & that was still not quite fast enough in aluminium...70,000 rpm would of been more adequate. Copper...ballpark guess would be 60,000. on a manual brigdeport...very light cuts & slow feed an alot of luck...will probabally get you a few broken bits. Damn...that thing looks like it has quite the length of cut for how small it is...

but what the hell...give the thing a try...could be fun to see what you dream up

I have heard of bits even smaller than these.... .005" in dia. I find its amazing that they can even make the damn things that small....& if you look under a magnifing glass at them...they are perfect...
Zymrgy is offline   Reply With Quote