ok, not that you should take my advice as being really knowledgeable, (i'm still designing my system) but two things that i've seen stated on these forums, first, gpu blocks are usually much less flow restrictive than the cpu block, so from a flow resistance point you'd be losing a LOT of flow to the cpu block by splitting the flow, generally not a good thing. second, and i can't remember where i saw this, gpu blocks are spec'd to run at higher temps generally than cpu's and since you don't mention that you plan to use a pelt there shouldn't be a huge jump in water temp. after the cpu block so plumbing it in series should be ok. just my $0.02. anybody else??
|