Quote:
Originally posted by pHaestus
Les:
I will have to look at my spreadsheet again as my number for W SHOULD agree with Bill's Swiftech data as they come from the same eqn. Perhaps an error in my goal seek?
The first set of full flow vs. half flow data was collected at 2200MHz and 2.0V whereas this is at 1.81V. There could be flow rate effects from this (higher W meaning higher flow rates seems reasonable)
|
Could well be me.Probably not worth locating the error unless is used for further sums and/or eror is compounded.
Yes,possibly shows the correct trend re Heat/CoolantTemp.However have to cross-check all the parameters before can be judged with any confidence. This is a chore especially if Flow-rate measurements are just round the corner.